Recent content by BENNETT87

Definitely get a multi socket set. If you need to take your clutch cover off to get access to the belt you will appreciate that. Additionally make sure to have a socket and ratchet for wheel nuts. Couple standard screw drivers and a hammer. It never hurts to have a spare belt as well.

I have edited the post to clean it up a bit making it easier to read.

7 Month 2024 Ridge XR Review The Bad to start: The Cab The Doors are made of a low quality way to flexible plastic, which shrinks in the cold conditions causing a gap in between the upper and lower panel. -There is also multiple warping in the plastic which does not look very high quality...

Yes, my machine did the same thing. Axles did it too. All I did was clean them up and paint them with a brush (black). The paint then machine them after for some odd reason.

Could have just been a loose connection. Usually when accessories are dim there is a ground out issue or positive terminal that isn't getting full contact.

Thank you, I took some really nice ones. I will share more of them.

Very minimal on level ground, but did notice a change in hill climbs. These units are sweet though so when tuning comes (reliable tuning) and clutching I am positive i will gain it back.

I did the upgrade right out of the gate. 32x10.50r15 coyote on 15 inch wheels. I am planning on swapping into 33inch radials next.